Contact Us


Whoops…Nothing found

Try other keywords in your search

Stereoscopic Mode In Pixera

 0 Minutes



Nvidia Settings


To start using a Stereoscopic workflow in Pixera you must first activate the feature inside the Nvidia Control Panel.



Pixera Setup


Begin by creating two displays, one of which will be for the left-side and one for the right-side of the Stereoscopic content. Then assign an output to both screens.



Next, place the content you want to appear on each side onto the respective screen. Make sure each screen is set to separate 3D Screen Groups, and then move the eyepoints as desired.


Finally you must set the Stereoscopic Mode if 3D is being used. This can be found in Mapping/Project after clicking on a Mapping/Feed and looking in the Inspector.



Pixera 2.0.31 | 18. March 2024

Was this article helpful?