Contact Us
In Pixera, it is possible to create LED walls using LED modules from many different manufacturers. Simply drag it from the library into the workspace and edit the settings in the Inspector.
To create an LED wall, an array of LED modules must be created. The characteristics can be defined using the horizontal and vertical input fields.To set a resolution other than the proposed one, the checkbox “Lock content resolution to physical resolution” must be deactivated.
Pixera allows the creation and editing of curved LED walls. This is done by adjusting the radius, panel angle, or chord length.
Radius
Defines the radius of the virtual circle on which the LED wall is placed. A smaller radius results in a stronger curvature, while a larger radius creates a flatter wall.
Panel Angle
Specifies the angle in degrees covered by a single LED panel along the circle. This value determines the rotation between adjacent panels.
Chord Length
Describes the straight-line distance between the two end points of a panel (chord of the circle) and corresponds to the physical width of the LED panel.
In the Inspector, all specifications for the selected LED module are displayed. In the Specifications tab, all modules of an LED wall can be replaced by clicking the Replace Module button.
Note!
Please note that if the perspective is modified (rotation, scaling, etc.) in the Compositing tab and a module is replaced using the Replace Module button, the perspective does not adapt to the newly selected panel. Enabling the Force Perspective Reset checkbox ensures that the perspective adapts to the new panel.
PIXERA 26.2 Inter 9 | 21. January 2026 | S.H.