Contact Us
Sending triggers when a pause cue leaves the cue position and not on entering the cue
Use Case
Once your timeline runs into a pause cue it is obvious that some action may need to be triggered upon the start of the next container after the pause cue. You can refer to the pause cue as a stand by for the next action that is supposed to happen. In many cases, you would want to execute a trigger to be sent at the time the now pointer leaves the pause cue.
Where to find the checkbox
Select the desired pause cue and open the “Network Command” section in the inspector. Directly below the Network Command, you can find the “Apply on Leave” Checkbox. Thick the checkbox and the command will be sent once you exit the cue instead of entering the cue. If you can't find the checkbox it may be that cue operation is not set to “Pause”.
PIXERA 25.1 RC6 | 14. May 2025 | O.K.